🔧 Huawei Y61 Deadboot Repair (Kirin 710F | UFS Dump File) | Shimul Service Point

 🔧 Huawei Y61 Deadboot Repair (Kirin 710F | UFS Dump File) | Shimul Service Point

Is your Huawei Y61 completely dead (no power, not detected in USB or Fastboot)? Don't worry! In this post, we’re sharing a tested UFS Dump File to fix Deadboot issues on Kirin-based Huawei Y61 using tools like Easy JTAG Plus, UFI, or Hydra.

---

📱 Device Information:

• Model: Huawei Y61

• SoC: Kirin 710F

• Storage Type: UFS

• Issue: Deadboot / No USB detection / No Fastboot

• Solution: Write Dump File to UFS chip via ISP or Direct Pinout

---

🧰 Required Tools:

• UFI Box / Easy JTAG Plus / Hydra Tool (UFS-supported)

• UFS Adapter or ISP Pinout Connection

• Tested Dump File (Download link below)

• Microsoldering equipment (for ISP connection)

---

📥 Download Dump File (100% Working)

👉 Download the Huawei Y61 UFS Dump File from the link below:

⬇️ Download Dump File

---

⚙️ How to Use:

1. Disassemble the phone and identify the UFS ISP pinout.

2. Connect the phone's UFS storage to your box using ISP or UFS adapter.

3. Load the dump file into your tool (UFI / JTAG).

4. Write the necessary partitions (BOOT1, BOOT2, LUN0 – depending on issue).

5. Once written, reflash stock firmware using Fastboot or Huawei Flash Tool.

6. Your phone should now boot normally.

---

⚠️ Important Notes:

• This file is only for Huawei Y61 Kirin 710F variant with UFS storage.

• Be sure to back up existing data if possible before writing.

• Use this method only if you're experienced with ISP and hardware flashing.

---

📞 Contact for Help:

Need remote repair service or professional guidance? We’re here to help!

📱 WhatsApp / Telegram: +8801912762051
🛠️ Blogger Site: Shimul Service Point